Our company always puts the concept of quality first in the top priority. Our responsibility is to provide Proffessional Diamond Hole Saw, Gasoline Water Pump, Coated Abrasives with stable quality, high cost performance and market competitiveness. 'Making better products and creating a more harmonious society' is our solemn commitment to the industry and society. Relying on the support of new and old customers, we will live up to expectations and create a better future. Our commitment is to respond promptly and accurately to customer requirements, be honest and trustworthy to customers, provide courteous service, and strive to continuously improve service quality.

Here is 4.5 inch grinding wheel, the grinding wheel is made of high quality aluminum oxide grains. It is specially used for grinding metal, It has an advantage of durability and efficient.

SALI 115x6x22.2mm grinding wheel with 2 nets
Promotion Restriction:	Not eligible for promotion for promotion
Arbor Hole size:	7/8", 22.2mm
Abrasive Wheel Diameter:	4.5", 115mm
Series:	Metal
Ideally Used With:	Angle grinder
Item:	Cut-off wheel 4-1/2"x1/4"x7/8", PK25
Packing:	5pcs each plastic bag; 25pcs each colorful inner box; 200pcs each colorful carton
Mini order:	1 carton each style

115x6x22.2mm grinding wheel, we sell more to Middle east and South America market.

Question: Why there are black spots on the periphery of the green film?

Reason: Z material overflows slightly.

Impact on the grinding wheel: It is only an appearance problem and has no effect on the performance of the grinding wheel.

Question: Why the metal ring is bigger or smaller?

Reason: The core ring feed is unqualified, too large or too small.

Impact on the grinding wheel: The core ring is too small, so that the grinding wheel cannot be installed on the grinding wheel shaft of the grinder and cannot be used; the core ring is too large, and the center of the grinding wheel is prone to deviation after installation, the dynamic balance increases, and there is no-load vibration.

Question: Why there is a difference for the thickness?

Reason: Caused by deviation of molding thickness.

Impact on the grinding wheel: When the thickness is large, the slit is wide, the grinding wheel is consumed, and the molding density is small, the sanding is fast, and the durability is deteriorated.

If the thickness is too small, the molding density will be too large, the sharpness will be worse, and the durability will be preferred.