We insist on quality control on every part, focusing on every detail, providing customers with reliable, high-quality and efficient Diagonal-Cutting Pliers, 7 Inch Diamond Blade, Heavy Duty Knife Wire Brush 0.3mm. We provide you with not only products, but also high-quality solutions and product services. We will continue to uphold the service concept of 'meet customer requirements and exceed customer expectations'. We are looking forward to cooperating with you. With an efficient and fast management concept, we wholeheartedly provide every customer with high-level products and comprehensive solutions. Today's cooperation is the beginning of tomorrow's development. We are willing to strengthen cooperation with you to create a better future.

Here is 4.5 inch grinding wheel, the grinding wheel is made of high quality aluminum oxide grains. It is specially used for grinding metal, It has an advantage of durability and efficient.

SALI 115x6x22.2mm grinding wheel with 2 nets
Promotion Restriction:	Not eligible for promotion for promotion
Arbor Hole size:	7/8", 22.2mm
Abrasive Wheel Diameter:	4.5", 115mm
Series:	Metal
Ideally Used With:	Angle grinder
Item:	Cut-off wheel 4-1/2"x1/4"x7/8", PK25
Packing:	5pcs each plastic bag; 25pcs each colorful inner box; 200pcs each colorful carton
Mini order:	1 carton each style

115x6x22.2mm grinding wheel, we sell more to Middle east and South America market.

Question: Why there are black spots on the periphery of the green film?

Reason: Z material overflows slightly.

Impact on the grinding wheel: It is only an appearance problem and has no effect on the performance of the grinding wheel.

Question: Why the metal ring is bigger or smaller?

Reason: The core ring feed is unqualified, too large or too small.

Impact on the grinding wheel: The core ring is too small, so that the grinding wheel cannot be installed on the grinding wheel shaft of the grinder and cannot be used; the core ring is too large, and the center of the grinding wheel is prone to deviation after installation, the dynamic balance increases, and there is no-load vibration.

Question: Why there is a difference for the thickness?

Reason: Caused by deviation of molding thickness.

Impact on the grinding wheel: When the thickness is large, the slit is wide, the grinding wheel is consumed, and the molding density is small, the sanding is fast, and the durability is deteriorated.

If the thickness is too small, the molding density will be too large, the sharpness will be worse, and the durability will be preferred.