How to use the paint roller brush
Roll before coating: clean the floating hair with water, soak the villi with water or diluent and shake dry the water, roll off the excess liquid on the waste paper and then dip the paint. Dip dip coating will only be half of the drum brush immersed in the material, and then in the drum tray uniform plate rolling back and forth a few times, so that the material evenly.
Rolling coating: top-down and bottom-up, according to the "W" shape will be rolled on the base, and then horizontal rolling; When brush roller is working, and then gently just the surface of the roller coating principle, the width of each roll is about four times the length of the drum, the drum is width and about a third of the overlap, lest coating forming roll mark intercourse, in order to ensure the uniform coating, save paint, roller coating when the strength should be evenly on both ends of the roller brush, roller coating containing material at the beginning of more, can be a little less hard, and then gradually increase, Operating hand and shoulder as far as possible not hard, just by the flip of the roller coating, the turning speed of the drum shoulds not be too fast, lest paint splash, influence of coating effect, as the movement wants light, always directors, card edge technique with the same brush, according to the size of the different area can use different size of roller.
After the roller brush is finished: stand the roller vertically on the table or the ground, with the other hand against the side of the cover, remove the roller cover from the bracket, clean the roller, remember to wash the roller brush when it is still wet, and place it in a ventilated place to dry, for the next use.
