First, before work
1. Wear good work clothes, with good goggles, long hair women will put up their hair and wear a work cap.
2. Check the tightness of power knife switch, saw blade, saw blade guard or safety baffle in detail. The operating table must be stable and there should be enough lighting for night operation.
3. Turn on the main switch, turn around for several times without load, and allow to start until it is confirmed safe.
Two, at work
1. Do not operate with gloves. Wear a mask or face mask if dust is caused during operation.
2. Do not try to cut the small workpiece that is not clamped tightly.
4. This machine is only allowed to cut profiles.
5. Do not carry out strong cutting and sawing operation. Make the motor reach full speed before cutting.
6. No one is allowed to stand behind the saw.
7. Do not lean over or around the saw machine. Do not release a hand or lift an arm from the saw or workpiece while the blade is still on.
8. Do not operate when the guard is not in place. Do not put your hand within 15 cm of the saw blade.
9. Power must be cut off before repairing or replacing accessories, and wait for the saw blade to stop completely.
10. If any abnormal sound is found, the examination should be stopped immediately.
Three, after work
1. Turn off the main power supply
2. Clean and tidy workstations and fields
Iv. In case of personal and equipment accidents, the site shall be maintained and reported to the relevant departments.
