1. Please hang the alloy saw blade vertically on a dry shelf. Be sure to avoid damp places. Never place the alloy saw blade flat on the ground or on a shelf. It will cause deformation of the alloy saw blade.
2. When using, do not exceed the specified maximum speed.
3. When using, you must wear protective covers, gloves, safety helmets, protective shoes, and protective glasses.
4. When installing the alloy saw blade, you must first confirm the performance and purpose of the saw table. It is best to read the saw table's manual first. In order to avoid incorrect installation and cause an accident.
5. When installing the alloy saw blade, you must first check whether the alloy saw blade is cracked, distorted, flattened, or tooth-dropped, etc., before installing it.
6. The teeth of the alloy saw blade are super hard and sharp. It is forbidden to collide or fall on the ground. It must be handled with care.
7. After installing the alloy saw blade, you must confirm whether the center hole of the saw blade is firmly fixed on the flange of the saw table. If there is a gasket, the gasket must be covered; then, gently push the saw blade by hand to confirm the saw Whether the piece rotates eccentrically and shakes.
8. The cutting direction indicated by the arrow of the alloy saw blade must be aligned with the rotation direction of the saw table. It is strictly forbidden to install in the opposite direction, the wrong direction will cause the tooth to fall.
9. Pre-rotation time: After replacing the alloy saw blade, it needs to pre-rotate for one minute before use, so that cutting can be performed when the saw table enters the working state.
10. Before cutting, you must confirm whether the purpose of the alloy saw blade is consistent with the material being cut.
11. When cutting the material, the saw blade in normal operation must be gently cut into the material, and it is forbidden to press hard and push hard.
12. Reversing is forbidden. Reversing will cause tooth loss and danger.
13. If you hear abnormal sound during use, or see abnormal shaking or uneven cutting surface, please stop the operation immediately and find the cause of the abnormality. Replace the saw blade.
14. When cutting, it is forbidden to stop the saw blade suddenly in the middle of the object to be cut. Stopping in the middle of the cutting object will cause the saw teeth to fall off and the saw blade to deform.
15. Please wipe the anti-rust oil in time after cutting. To prevent the saw blade from rusting.
16. When the saw teeth are not sharp, the saw teeth should be ground again. You must take it to the grinding shop designated by the manufacturer or a store with grinding technology for grinding. Otherwise, the original angle of the saw teeth will be destroyed, cutting accuracy will be affected, and the service life of the saw blade will be shortened.
