Abrasives Flat Type Cut off Wheel for Steel 180mm

We have outstanding product design and production capabilities in the field of Jet Pump, T42 Grinding Wheel For Stone, Cutting Disc For Metal. The market has higher and higher expectations for product quality and research and development capability. Our company focuses on developing new products and improving product quality. We are dedicated to providing professional services to our customers, continuously pursuing customer satisfaction, striving to exceed customer expectations, and being a partner of our customers forever. And we had weed out suppliers with poor quality.

Here is 9 inch cutting wheel for stainless steel, inox,  the cutting disc is made of high quality single aluminum oxide grains. It is especially used for cutting stainless steel. Due to the supper think, it has fast cutting while have excellent durability feature.

Question: The flange of the product center falls off?

Answer:

1. The product becomes soft during cutting, which leads to swinging during cutting. After a long time, cracks occur on the circumference outside the flange and finally break away from the grinding wheel itself;

2. The workpiece is not effectively fastened, and the workpiece is moved left or right during cutting, and the grinding wheel for vertical cutting becomes curved and cut. After a long time, the result is the same as above;

3. The flange does not effectively fasten the grinding wheel. When rotating at high speed, the grinding wheel and the flange do not run synchronously, which causes the flange to rub the grinding wheel. After a long time, the result is the same as above.

4.The grinding wheel is not clamped.

5. The product aperture does not match the device shaft aperture.

Question: Why the edge is chipping?

Answer:

1. The contact with the workpiece is too fast and a hard collision occurs.

2. The grinding angle is too small.

3. The product is hard.

[[ContDescription]]