Abrasives Flat Type Cut off Wheel 125mm

The 36 Grit Grinding Wheel For Innox, Diamond Grinding Wheel With Turbo, Drill Bit And Chuck we offer are all designed and produced by our professionals, and can be said to be the most cost-effective products in the market. Our company continuously improves our business process, shortens product production cycle, controls enterprise cost, and improves our competitiveness. Unity is the basic guiding ideology for the good development of an enterprise, and we always abide by it.

Here is 9 inch cutting wheel for stainless steel, inox,  the cutting disc is made of high quality single aluminum oxide grains. It is especially used for cutting stainless steel. Due to the supper think, it has fast cutting while have excellent durability feature.

Question: The flange of the product center falls off?

Answer:

1. The product becomes soft during cutting, which leads to swinging during cutting. After a long time, cracks occur on the circumference outside the flange and finally break away from the grinding wheel itself;

2. The workpiece is not effectively fastened, and the workpiece is moved left or right during cutting, and the grinding wheel for vertical cutting becomes curved and cut. After a long time, the result is the same as above;

3. The flange does not effectively fasten the grinding wheel. When rotating at high speed, the grinding wheel and the flange do not run synchronously, which causes the flange to rub the grinding wheel. After a long time, the result is the same as above.

4.The grinding wheel is not clamped.

5. The product aperture does not match the device shaft aperture.

Question: Why the edge is chipping?

Answer:

1. The contact with the workpiece is too fast and a hard collision occurs.

2. The grinding angle is too small.

3. The product is hard.

[[ContDescription]]