9 Inch Metal Cut off Wheel

Over the years, we have always adhered to a firm belief and committed to bringing assured Diamond Blade For Circular Saw, Saw Blade For Wood, Pump Pliers to consumers. Our company has constructed a high efficiency, low-cost organization system, with high-quality and low-cost products to dedicate to the majority of consumers. We will continue to unite and forge ahead, lead the staff to be market-oriented, do a good job in product research and development and strengthen scientific management. We sincerely welcome you to visit our company or contact us for cooperation! When cooperation together with the customer, we provide shoppers with the highest high-quality of service.

Here is 9 inch cutting wheel for stainless steel, inox,  the cutting disc is made of high quality single aluminum oxide grains. It is especially used for cutting stainless steel. Due to the supper think, it has fast cutting while have excellent durability feature.

Question: The flange of the product center falls off?

Answer:

1. The product becomes soft during cutting, which leads to swinging during cutting. After a long time, cracks occur on the circumference outside the flange and finally break away from the grinding wheel itself;

2. The workpiece is not effectively fastened, and the workpiece is moved left or right during cutting, and the grinding wheel for vertical cutting becomes curved and cut. After a long time, the result is the same as above;

3. The flange does not effectively fasten the grinding wheel. When rotating at high speed, the grinding wheel and the flange do not run synchronously, which causes the flange to rub the grinding wheel. After a long time, the result is the same as above.

4.The grinding wheel is not clamped.

5. The product aperture does not match the device shaft aperture.

Question: Why the edge is chipping?

Answer:

1. The contact with the workpiece is too fast and a hard collision occurs.

2. The grinding angle is too small.

3. The product is hard.

[[ContDescription]]