Competition in the market has led to goods being produced cheaply and a consequent deterioration in quality, but our Coated Abrasives, High Pressure Washer 180 Bar, Crimp Circular Wire Brush are of high quality and able to compete internationally. We take quality service as the purpose, reflecting the value of society and ourselves, is to build a comprehensive service provider. We start from the concept change and development strategy to improve the overall competitiveness level of our company, which is conducive to our company's going to the world and carrying out cooperation and competition with foreign investors in the domestic market. Our company has convenient customs clearance measures, we open the procedures and time limit to ensure the smooth flow of complaint calls and consultation hotline.

Here is 9 inch cutting wheel for stainless steel, inox, the cutting disc is made of high quality single aluminum oxide grains. It is especially used for cutting stainless steel. Due to the supper think, it has fast cutting while have excellent durability feature.

SALI 230x2x22.2mm cutting wheel Specification
Promotion Restriction:	Not eligible for promotion for promotion
Arbor Hole size:	7/8" 22.2mm
Abrasive Wheel Diameter:	9", 230mm
Series:	Stainless steel
Ideally Used With:	7inch Angle grinder
Item:	Cut-off wheel 7"x3/64"x7/8", PK25
Packing:	25pcs each plastic bag; 50pcs each color inner box; 100pcs each colorful carton
Mini order:	1 carton each style

Question: The flange of the product center falls off?

Answer:

1. The product becomes soft during cutting, which leads to swinging during cutting. After a long time, cracks occur on the circumference outside the flange and finally break away from the grinding wheel itself;

2. The workpiece is not effectively fastened, and the workpiece is moved left or right during cutting, and the grinding wheel for vertical cutting becomes curved and cut. After a long time, the result is the same as above;

3. The flange does not effectively fasten the grinding wheel. When rotating at high speed, the grinding wheel and the flange do not run synchronously, which causes the flange to rub the grinding wheel. After a long time, the result is the same as above.

4.The grinding wheel is not clamped.

5. The product aperture does not match the device shaft aperture.

Question: Why the edge is chipping?

Answer:

1. The contact with the workpiece is too fast and a hard collision occurs.

2. The grinding angle is too small.

3. The product is hard.