SALI Pressure Tank Sand Fiber Wheel

Red steel paper - made of cotton beating and pressing, its characteristics is elastic toughness environmental protection, in the use of the process of self-repair balance, this is the purpose of choosing steel paper as the matrix! Two: abrasion-silicon carbide, characteristics is strong self-sharpening, generally suitable for stone, airport floor, resin curing after grinding such as wind power blades FRP, steel oxide layer! Three: adhesive: phenolic resin, its characteristics are high temperature resistance, moisture resistance, in the general harsh environment does not affect the use of its cementation.

Moq: 

Sali is a moQ, no limit, OEM unknown

Price impact:

 MoQ material packaging

Buy: 

wear plastic plate to use, not with the stability is not good, the center hole will crack off not firm;

Other: 

silicon carbide trough sand plate grain number difference paper base back base thickness is not the same can be with holes and without

Note:

 Small pieces generally do not have holes, 7-inch inventory goods are with holes, holes are used for chip removal, it is not easy to plug, the main body of the trough sand plate is steel paper, so it must be used with plastic accessories, otherwise the product is easy to shake left and right, serious steel paper fracture and flying pieces hurt people. Products are suitable for granite, marble, wall, wind power blades, resin board grinding, widely used in stone factories and shipyards, as well as the polishing of paint on the floor, not easy to cause blockage.

Correct usage:

First, the product model must be matched with the Angle mill model number! For example :180 red paper slotting sand plate with 180 Angle mill, because the model is not the same as the speed is not the same, the standard speed of slotting sand plate is idling 80 m/s! If 180 slotted sand plate with 125 Angle mill has vibration or splitter or burning possibility!

Ii. Installation requirements and steps: The installation of the steel paper slotted sand disc is different from that of the grinding wheel. It must be supported by a lining tray, and the diameter of the general liner shall not be less than 80% of the product diameter strictly.